LOADING

Type to search

Restorative Dentistry

Class 2 Composite Restoration: How to Etch & Bond?

This Workflow Component is presented by Dr. Stephen Ferrier from the Schulich School of Dentistry at Western University

Dr. Stephen Ferrier is Assistant Professor in the Division of Restorative Dentistry at Western University 

1. Key Concepts
2. Clinical bonding sequence
3. General information about bonding systems

4. Different bonding systems

5. Comparing Different Bonding Systems

 

Figures redrawn from Fundamentals of Operative Dentistry – A Contemporary Approach, Third Edition, Schwartz et. al. Qunitessence Publishing

 

Do you have any particular question on this topic? Do you have any comments or suggestions? Email us at oasisdiscussions@cda-adc.ca

Your are invited to comment on this post and provide further insights by posting in the comment box which you will find by clicking on “Leave a reply“ below. You are welcome to remain anonymous and your email address will not be posted.

 

 

2 Comments

  1. geoff August 1, 2013

    Very nice, concise discussion, however I didn’t see any reference to primary teeth.

    Reply
  2. Larry F August 2, 2013

    Dr. Ferrier’s article on bonding for class two composites is very good. It is the first OASIS article I’ve read seriously. Will there be a follow-up article on “Getting Good Contacts”? And how about “Preventing Post-Op Sensitivity in Posterior Composites? Both would be most welcome. Such articles should be considered fundamental to dentistry and worth reviewing often.

    Reply

Leave a Comment

Your email address will not be published. Required fields are marked *